Curling iron to make spiral curls free#

Repeated the process, segment by segment, until we had fully curled the entire panel in layers of spiral curls. We continued with the next slice of the bottom segment, and Once more, we held the iron in place for a few seconds, and then unwound the iron in place a bit, enabling us to slide the iron out the end of the curl. The difference is that we positioned the segment so that it was at the base of the iron,Īnd we rolled the iron so that the hair wound at an angle, overlapping slightly until we reached the scalp. For spiral curls, we continue by dividing the horizontal segments into slices of about half to three-quarters of an inch square.Īs with the segments for the barrel curl, we applied a small amount of hairspray and slid the segment into the curling iron. Once again, we separated a panel of hair to work with, and further divide the panel Once cooled, barrel curls can be combed or brushed out and styled as desired.Īfter finishing the barrel curls, we turn to the left side of the manikin and prepare to create the spiral curls. Made sure to let them cool completely to set the curls fully. Should be adjusted downwards to prevent burning your hair.įor our demonstration, we continued with the other segments of the panel, and also curled half of the bangs on the manikin with a barrel curl. A little steam is alright, but if there is any smoke, scorching, or discoloration, your iron is too hot and the temperature Hould only be slightly damp, not wet) and place it between the clamp and plate of the iron. To test your iron, lightly moisten a piece of tissue paper with water (it s Note: You should always test your curling iron before you place it against the hair, unless you are sure of the temperature of the iron. We held the iron in place for a few seconds, until the heat thoroughly penetrated the hair, then carefully unwound the iron in place and slid it from the curl. You can use a comb laid flat against the head to prevent the iron from resting on the scalp and accidentally burning yourself. Turned the iron to roll the hair onto the barrel, stopping just short of the scalp.

Curling iron to make spiral curls free#

Panel, we combed the hair to make sure it was free of tangles then lightly misted the hair with hairspray.Īt this point, we took the curling iron in hand and inserted the segment of hair between the clamp and barrel of the iron, sliding the iron down to the ends of the hair so that the clamp covered them. Starting with the bottom-most segment of the Once this was done, we began creating the curls. We then proceeded to divide the panel into segments about as thick as our curling iron and clip them up out of the way. Narrower than the length of our curling iron's barrel. To begin creating barrel curls, we divided our manikin's hair along the center parting, and sectioned off a panel of hair on the right side just before the ear. Barrel curls are the type of curl you get from standard roller sets, but with a curling iron, you can get the same effect in a fraction of the